Intel Wifi Link 5100 Linux Drivers For Mac

31.01.2020

Drivers

my notebook is thinkpad t400,
intel wifi link 5100,
linux kernel 2.6.27,
system fedora 9 ,
I've install as many drivers as I can and the wlan0 LED can be lighted up,but cannot work properly.
I've spent a lot of time on these problems,please guide me how to solve them?
#ifup wlan0
Error for wireless request 'Set Mode' (8B06) :
SET failed on device wlan0 ; Invalid argument.
Error for wireless request 'Set Encode' (8B2A) :
SET failed on device wlan0 ; Invalid argument.
determining wlan0 IP ..
#iwconfig wlan0
wlan0 IEEE 802.11abgn ESSID:'TP-LINK'
Mode:Managed Frequency:2.412 GHz Access Point: Not-Associated
Tx-Power=15 dBm
Retry min limit:7 RTS thrff Fragment thr=2352 B
Encryption keyff
Power Managementff
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
#lshw -C network
*-network
description: Ethernet interface
product: 82567LM Gigabit Network Connection
vendor: Intel Corporation
physical id: 19
bus info: pci@0000:00:19.0
logical name: eth0
version: 03
serial: 00:1c:25:96:33:6f
size: 100MB/s
capacity: 1GB/s
width: 32 bits
clock: 33MHz
capabilities: pm msi bus_master cap_list ethernet physical tp 10bt 10bt-fd 100bt 100bt-fd 1000bt-fd autonegotiation
configuration: autonegotiation=on broadcast=yes driver=e1000e driverversion=0.3.3.3-k6 duplex=full firmware=1.8-3 ip=192.168.1.102 latency=0 link=yes module=e1000e multicast=yes port=twisted pair speed=100MB/s
*-network
description: Wireless interface
product: Intel Corporation
vendor: Intel Corporation
physical id: 0
bus info: pci@0000:03:00.0
logical name: wmaster0
version: 00
serial: 00:21:5d:46:52:2c
width: 64 bits
clock: 33MHz
capabilities: pm msi pciexpress bus_master cap_list logical ethernet physical wireless
configuration: broadcast=yes driver=iwlagn latency=0 module=iwlagn multicast=yes wireless=IEEE 802.11abgn
*-network DISABLED
description: Ethernet interface
physical id: 2
logical name: pan0
serial: 92:7c:9e:d6:8e:7d
capabilities: ethernet physical
configuration: broadcast=yes driver=bridge driverversion=2.3 firmware=N/A link=yes multicast=yes
#dmesg
iwlagn: Intel(R) Wireless WiFi Link AGN driver for Linux, 1.3.27kds
iwlagn: Copyright(c) 2003-2008 Intel Corporation
iwlagn 0000:03:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17
iwlagn 0000:03:00.0: setting latency timer to 64
iwlagn: Detected Intel Wireless WiFi Link 5100AGN REV=0x54
iwlagn: Tunable channels: 13 802.11bg, 24 802.11a channels
iwlagn 0000:03:00.0: PCI INT A disabled
phy0: Selected rate control algorithm 'iwl-agn-rs'
HDA Intel 0000:00:1b.0: PCI INT B -> GSI 17 (level, low) -> IRQ 17
HDA Intel 0000:00:1b.0: setting latency timer to 64
........
iwlagn 0000:03:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17
iwlagn 0000:03:00.0: restoring config space at offset 0x1 (was 0x100102, writing 0x100106)
firmware: requesting iwlwifi-5000-1.ucode
Registered led device: iwl-phy0:radio
Registered led device: iwl-phy0:assoc
Registered led device: iwl-phy0:RX
Registered led device: iwl-phy0:TX
ADDRCONF(NETDEV_UP): wlan0: link is not ready
.............
iwlagn 0000:03:00.0: PCI INT A disabled
iwlagn 0000:03:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17
iwlagn 0000:03:00.0: restoring config space at offset 0x1 (was 0x100102, writing 0x100106)
iwlagn: Error sending REPLY_ADD_STA: time out after 500ms.
Registered led device: iwl-phy0:radio
Registered led device: iwl-phy0:assoc
Registered led device: iwl-phy0:RX
Registered led device: iwl-phy0:TX
ADDRCONF(NETDEV_UP): wlan0: link is not ready
Here's the deal:
I have a Toshiba Satellite M305-S4910 notebook on which I have installed Linux Mint 8 Main. The wireless adapter is an Intel Wifi Link 5100 agn and I've tried everything I could find to get it to work. Network manager does not show that the card is available. I tried everything from the MintWifi wiki, and I tried downloading and replacing the microcode (I kept the originals just in case.) I Googled, and I searched these forums . . . nothing has worked. I tried the LiveCD and the wifi doesn't work with that, either - just a bunch of lines running down the screen during boot, saying 'MAC is in deep sleep!'
  • Feb 18, 2009  i was wondering since the latest ubuntu version has intel 5100 agn working is there any chance it will be working on osx86 or does any1 know how to create a 5100 kext to get it to work? I would be willing to try to create the kext but i prob am not smart enough with unix yet.
  • In that case, OP will have to upgrade or replace the Intel wifi 5100 adapter with a newer model when upgrading to Windows 10. I know for sure Windows 8 & 8.1 had built-in (in-box) drivers for Intel WiFi 5100 & 5300 adapters though I'm not sure if Windows 10 has in-box drivers for those old wifi adapters.
  • Intel® Wireless WiFi Link 5100 (not work). There are any way to use it in mac os x? I have the same wireless. It would be great if the Linux driver could.
  • The wireless adapter is an Intel Wifi Link 5100 agn and I've tried everything I could find to get it to work. Network manager does not show that the card is available. I tried everything from the MintWifi wiki, and I tried downloading and replacing the microcode (I kept the originals just in case.).

Need a kext for Network controller: Intel Corporation Wireless WiFi Link 5100 too:) This card is working now in linux, and there is drivers for it (using it now, in my Gentoo 64bit) Maybe can have a port for leo?

If it counts as useful information, I tried using the Windows driver with ndiswrapper as well with no luck. It shows that the hardware is not present, and iwconfig won't show it. But I have noted that the driver provided by Toshiba is a Realtec driver. Also it may be useful to know that I have Windows 7 64-bit dual booting with Linux Mint x86 but I did try the x86 driver (the x64 was a definite no-go as it said, 'invalid driver.')Hp linux drivers
Following are the requisite terminal outputs:
Output of mintWifi.py:
-------------------------
* I. scanning WIFI PCI devices..
-- Intel Corporation Wireless WiFi Link 5100
> PCI ID = 8086:4232
-------------------------
* II. querying ndiswrapper..
-------------------------
* III. querying iwconfig..
lo no wireless extensions.
-------------------------
* IV. querying ifconfig..
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:130 errors:0 dropped:0 overruns:0 frame:0
TX packets:130 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:14683 (14.6 KB) TX bytes:14683 (14.6 KB)
-------------------------
* V. querying DHCP..
Internet Systems Consortium DHCP Client V3.1.2
Copyright 2004-2008 Internet Systems Consortium.
All rights reserved.
For info, please visit http://www.isc.org/sw/dhcp/
No broadcast interfaces found - exiting.
-------------------------
* VI. querying nslookup google.com..
;; connection timed out; no servers could be reached
Output of lspci:
00:00.0 Host bridge: Intel Corporation Mobile 4 Series Chipset Memory Controller Hub (rev 07)
00:02.0 VGA compatible controller: Intel Corporation Mobile 4 Series Chipset Integrated Graphics Controller (rev 07)
00:02.1 Display controller: Intel Corporation Mobile 4 Series Chipset Integrated Graphics Controller (rev 07)
00:1a.0 USB Controller: Intel Corporation 82801I (ICH9 Family) USB UHCI Controller #4 (rev 03)
00:1a.1 USB Controller: Intel Corporation 82801I (ICH9 Family) USB UHCI Controller #5 (rev 03)
00:1a.2 USB Controller: Intel Corporation 82801I (ICH9 Family) USB UHCI Controller #6 (rev 03)
00:1a.7 USB Controller: Intel Corporation 82801I (ICH9 Family) USB2 EHCI Controller #2 (rev 03)
00:1b.0 Audio device: Intel Corporation 82801I (ICH9 Family) HD Audio Controller (rev 03)
00:1c.0 PCI bridge: Intel Corporation 82801I (ICH9 Family) PCI Express Port 1 (rev 03)
00:1c.4 PCI bridge: Intel Corporation 82801I (ICH9 Family) PCI Express Port 5 (rev 03)
00:1c.5 PCI bridge: Intel Corporation 82801I (ICH9 Family) PCI Express Port 6 (rev 03)
00:1d.0 USB Controller: Intel Corporation 82801I (ICH9 Family) USB UHCI Controller #1 (rev 03)
00:1d.1 USB Controller: Intel Corporation 82801I (ICH9 Family) USB UHCI Controller #2 (rev 03)
00:1d.2 USB Controller: Intel Corporation 82801I (ICH9 Family) USB UHCI Controller #3 (rev 03)
00:1d.7 USB Controller: Intel Corporation 82801I (ICH9 Family) USB2 EHCI Controller #1 (rev 03)
00:1e.0 PCI bridge: Intel Corporation 82801 Mobile PCI Bridge (rev 93)
00:1f.0 ISA bridge: Intel Corporation ICH9M LPC Interface Controller (rev 03)
00:1f.2 SATA controller: Intel Corporation ICH9M/M-E SATA AHCI Controller (rev 03)
00:1f.3 SMBus: Intel Corporation 82801I (ICH9 Family) SMBus Controller (rev 03)
07:00.0 Ethernet controller: Marvell Technology Group Ltd. 88E8040T PCI-E Fast Ethernet Controller (rev 12)
08:00.0 Network controller: Intel Corporation Wireless WiFi Link 5100
0a:01.0 FireWire (IEEE 1394): O2 Micro, Inc. Firewire (IEEE 1394) (rev 02)
0a:01.2 SD Host controller: O2 Micro, Inc. Integrated MMC/SD Controller (rev 02)
0a:01.3 Mass storage controller: O2 Micro, Inc. Integrated MS/xD Controller (rev 01)
Pertinent output of lspci -nnvv:Linux
Network controller [0280]: Intel Corporation Wireless WiFi Link 5100 [8086:4232]
Subsystem: Intel Corporation Device [8086:1201]
Control: I/O- Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
Interrupt: pin A routed to IRQ 17
Region 0: Memory at b6100000 (64-bit, non-prefetchable)
Capabilities: <access denied>
Kernel driver in use: iwlagn
Kernel modules: iwlagn

I'm sorry if I've left anything out or posted something wrong, but I've been at this for three days now, and with the kind of work I put in, that totally counts as paying my dues. Is there any hope?
***EDIT: In case it helps, I have found that a Fedora 12 LiveCD finds and uses my wireless adapter correctly. But I am not giving up on Mint if I don't have to.
Pertinent output of lspci -nnvv in Fedora 12:
08:00.0 Network controller [0280]: Intel Corporation Wireless WiFi Link 5100 [8086:4232]
Subsystem: Intel Corporation Device [8086:1201]
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
Latency: 0, Cache Line Size: 64 bytes
Interrupt: pin A routed to IRQ 30
Region 0: Memory at b8100000 (64-bit, non-prefetchable)
Capabilities: <access denied>
Kernel driver in use: iwlagn
Kernel modules: iwlagn

Pertinent output of lspci in Fedora 12:

Ati Linux Drivers

08:00.0 Network controller: Intel Corporation Wireless WiFi Link 5100